LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

  1. Install the ignition switch assembly (2) and secure by using 2 tapping screws (3).

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

    Fig 1: View Of Ignition Lock Cylinder Case, Ignition Switch, Retaining Screws & Key Alarm Connector
    GM324871Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the ignition switch assembly connector (1) onto the ignition lock cylinder case (4).
  3. Connect the theft deterrent control module connector.
  4. Connect the fused jumper assembly connector.
    Fig 2: View of Fused Jumper Assembly Connector
    GM420192Courtesy of GENERAL MOTORS CORP.
  5. Install the theft deterrent control module (2) onto the ignition lock cylinder case (1).
    Fig 3: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  6. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals