LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

  1. Align the ignition lock cylinder case (1) with the steering column tilt head assembly.
    Fig 1: View Of Ignition Lock Cylinder Case Assembly & Screws
    GM664260Courtesy of GENERAL MOTORS CORP.
  2. Screw the 3 TORX® screws (2) into the ignition lock cylinder case (1).

    Tighten:  Tighten the 3 TORX® screws to 7 N.m (62 lb in).

    NOTE: Refer to Fastener Notice .
  3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
    Fig 2: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
  4. Install the turn signal switch housing. Refer to Turn Signal Switch Housing Replacement .
    Fig 3: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly
    GM664269Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Press the turn signal switch housing firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly to align.
  5. Install the turn signal and multifunction switch assembly only. Refer to Turn Signal Multifunction Switch Replacement .
  6. Install the steering column tilt head components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
  7. Install the ignition switch only. Refer to Ignition and Start Switch Replacement .
  8. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals