Passenger Presence System scan tool data definitions

The scan tool displays 0-20 volts. This is the system voltage measured by the PPS module between the battery input and ground.

The scan tool displays the current power mode.

The scan tool displays the current condition of the PPS system to determine if the SDM or PPS is causing the PPS Disabled condition.

The scan tool displays the current status of the PPS system within the SDM. When disabled, SDM will default to deactivate the deployment loops related to the passenger airbags. PPS Fault Status and SDM Fault status should match.

The scan tool displays the current status of the PPS system. This information is sent to the SDM for deactivation of the deployment loops related to the passenger airbags. PPS Enable Status and SDM Enable status should match.

The scan tool displays the calculated seat occupant status or need to re-zero.

The scan tool displays the calculated seat occupant status including relationship to seat position.

The scan tool displays the voltage determined by the weight/position of the seat occupant.

The scan tool displays voltage which is used to determine whether a child infant seat is mounted in the passenger seat or not.

The scan tool displays the status of the primary key based on the comparison between the BCM and the PPS. If the Status is other than Valid the PPS will not allow activation and should set a DTC.

The scan tool displays primary key that the PPS has stored to memory.

The scan tool displays what the PPS received from the BCM as the primary key. The PPS then compares it to what it has stored to determine the Primary Key Status. The PPS Primary Key and Received Primary Key should match.