Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Clean and prepare all of the welded surface and apply 3M weld-thru coating P/N 05916 or equivalent as necessary.

Fig 1: View Of Tow Hook - Front

Courtesy of GENERAL MOTORS CORP.

Position the tow hook (1) to the passenger side of the impact bar.

Fig 2: View Of Tow Hook & Impact Bar - Front

Courtesy of GENERAL MOTORS CORP.

From the right outer edge of the impact bar (2) measure 269 mm (10 5/8 in) to the center of the tow hook (1).

Fig 3: View Of Welds - Front

Courtesy of GENERAL MOTORS CORP.

Using a metal inert gas (MIG) welder, weld a 51 mm (2 in) stitch along the tow hook to the impact bar in 4 places (1).
- Front
- Rear
- Inboard side
- Outboard side
Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair .
Paint the repair area. Refer to Basecoat/Clearcoat Paint Systems .
Install all related panels and components.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L) or Battery Negative Cable Disconnection and Connection (7.0L) .
Enable the SIR system. Refer to SIR Disabling and Enabling .