Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Torrent and 2006 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Install the proportioning valve assembly to the vehicle.
- Install the proportioning valve mounting bolts.
Tighten: Tighten the bolts to 12 N.m (106 lb in).
- Remove the plugs from the proportioning valve assembly ports.
- Remove the caps or plugs from the master cylinder brake pipe ends.
- Connect the master cylinder brake pipes to the proportioning valve assembly.
- Tighten the brake pipe fittings at the proportioning valve assembly.
Tighten: Tighten the fittings to 18 N.m (13 lb ft).
- Remove the caps or plugs from the caliper and wheel cylinder brake pipe ends.
- Connect the caliper and wheel cylinder brake pipes to the proportioning valve assembly.
- Tighten the brake pipe fittings at the proportioning valve assembly.
Tighten: Tighten the fittings to 18 N.m (13 lb ft).
- Remove the shop towel and discard into an approved container.
- Reposition the TCM with bracket to the bracket on the strut tower. Refer to Transaxle Control Module Replacement in Automatic Transaxle - AF33-5.
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.