Installation Procedure
- Install the following components to the power steering pump rear bracket (1):
- The power steering pump (2).
- The power steering pump front bracket (3).
- Install the power steering pump mounting bolts (4) to the power steering pump (2).
Tighten: Tighten the bolts to 25 N.m (18 lb ft).
- Install the power steering reservoir outlet pipe/hose to the power steering pump. Refer to Power Steering Reservoir Outlet Pipe/Hose Replacement .
- Install the power steering pressure hose to the power steering pump. Refer to Power Steering Pressure Pipe/Hose Replacement .
- Install the power steering pump pulley. Refer to Power Steering Pulley Replacement .
- Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement .
- Install the Brake Pressure Modulator Valve (BPMV) bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement in Antilock Brake System.
- Install the Brake Pressure Modulator Valve (BPMV). Refer to Brake Pressure Modulator Valve Replacement in Antilock Brake System.
- Bleed the power steering system. Refer to Power Steering System Bleeding .
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.