LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 7 >> Disabling Procedure

Disabling Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
  2. Place the ignition in the OFF position.
    3. Fig 1: Kick-Up Panel, I/P Fuse Block & Cover
    GM1246577Courtesy of GENERAL MOTORS CORP.
  3. Remove the kick-up panel (2) to expose the instrument panel (I/P) fuse block.
  4. Remove the I/P fuse block cover (1).
    Fig 2: Identifying SDM Fuse
    GM1246574Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: With the SDM fuse removed and the ignition in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.
  5. Locate the SDM fuse within the I/P fuse block.
  6. Remove the SDM fuse from the I/P fuse block.
    7. Fig 3: View Of CPA, Seat Belt Pretensioner Yellow Connector & Vehicle Harness Yellow Connector
    GM854382Courtesy of GENERAL MOTORS CORP.
  7. Remove both connector position assurance (CPA) (3) from the LF/driver side impact module and pretensioner yellow connector (1) which is located under the driver seat.
  8. Disconnect the vehicle harness yellow connector (2) from the LF side impact module and pretensioner yellow connector (1).
scientia non olet · About LEMON Manuals