LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 5 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition in the OFF position.
    2. Fig 1: Locating Inflatable Restraint I/P Module Connector
    GM217468Courtesy of GENERAL MOTORS CORP.
  2. Connect the I/P module yellow connector to the vehicle harness yellow connector.
  3. Install the CPA to the vehicle harness yellow connector.
  4. Install the right sound insulator to the I/P. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower in Instrument Panel, Gages, and Console.
    5. Fig 2: Kick-Up Panel, I/P Fuse Block & Cover
    GM1246577Courtesy of GENERAL MOTORS CORP.
  5. Install the SDM fuse into the I/P fuse block.
  6. Install the I/P fuse block cover (1).
  7. Install the kick-up panel (2) to cover the I/P fuse block (1).
  8. Use caution while reaching in and place the ignition to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  9. Perform the Vehicle System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals