LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 1 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition in the OFF position.
    2. Fig 1: Identifying Left/Right Connector Position Assurance, Left/Right Electronic Frontal Sensors & Left/Right EFS Connectors
    GM1246631Courtesy of GENERAL MOTORS CORP.
  2. Connect both the right and left front end sensor connector (2, 5) to the right and left front end sensor (1, 4).
  3. Connect both the right and left CPA (3, 6) to the right and left front end sensor connector (2, 5).
  4. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 6.0L.
    5. Fig 2: Kick-Up Panel, I/P Fuse Block & Cover
    GM1246577Courtesy of GENERAL MOTORS CORP.
  5. Install the SDM fuse into the I/P fuse block.
  6. Install the I/P fuse block cover (1).
  7. Install the kick-up panel (2) to cover the I/P fuse block (1).
  8. Use caution while reaching in and place the ignition to the ON position. The AIR BAG indicator will flash then turn OFF.
  9. Perform the Vehicle System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals