LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Fuse Block Cable Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Fuse/Relay Center Stud & Positive Battery Cable Lead
    GM675309Courtesy of GENERAL MOTORS CORP.
  1. Remove the battery tray. Refer to Battery Tray Replacement .
  2. Open the stud cover on the fuse/relay center cover.
  3. Remove the positive battery cable nut (1).
  4. Remove the positive battery cable lead from the stud.
  5. Remove the battery positive fuse block cable from the stud.
    6. Fig 2: Kick-Up Panel Upper Latches
    GM71195Courtesy of GENERAL MOTORS CORP.
  6. Disengage the kick-up panel latches inside the vehicle.
  7. Open the panel.
  8. Lift the panels bottom edge up and out of the slots in the multi-use relay bracket.
  9. Remove the kick-up panel.
    10. Fig 3: I/P Wiring Harness Junction Block & Nut
    GM675311Courtesy of GENERAL MOTORS CORP.
  10. Unsnap the junction block from the bracket.
  11. Reposition the junction block nut boot.
  12. Remove the instrument panel (I/P) wiring harness junction block nut.
  13. Remove the battery positive fuse block cable from the stud.
  14. Route the fuse block cable through the front of dash and remove the cable.
scientia non olet · About LEMON Manuals