Installation Procedure

Fig 1: View Of Turn Signal & Multifunction Switch Assembly

Courtesy of GENERAL MOTORS CORP.

Install the turn signal and multifunction switch assembly (2) to the steering column tilt head assembly.

NOTE: Refer to Fastener Notice .

Install the 2 screws (1) to the turn signal and multifunction assembly.
Tighten: Tighten the screws to 3 N.m (27 lb in).

Fig 2: Turn Signal & Multifunction Switch Assembly Connectors

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Steering Column Wire Harness Assembly & Wire Harness Strap

Courtesy of GENERAL MOTORS CORP.

Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement .
Install the steering wheel. Refer to Steering Wheel Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .