LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T65-E - Introduction (2 Of 2) >> Repair Instructions >> Torque Converter Cover Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Torque Converter Cover Bolts
    GM289471Courtesy of GENERAL MOTORS CORP.
  1. Install the torque converter cover.
    2. NOTE: Refer to Fastener Notice .
  2. Install the torque converter cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Removing/Installing Transmission Brace
    GM1544756Courtesy of GENERAL MOTORS CORP.
  3. Install the transaxle brace (4). Refer to Automatic Transmission Brace Replacement (Front Wheel Drive) , Automatic Transmission Brace Replacement (All Wheel Drive)  or Automatic Transmission Brace Replacement (Front Wheel Drive and All Wheel Drive) .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals