LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating MAP Sensor Electrical Connector
    GM1675732Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to INTAKE MANIFOLD COVER REPLACEMENT .
  2. Disconnect the engine harness electrical connector (1) from the manifold absolute pressure (MAP) sensor.
  3. Remove the MAP sensor bracket bolts and bracket.
    4. Fig 2: Identifying MAP Sensor Electrical Connector
    GM1639213Courtesy of GENERAL MOTORS CORP.
  4. Remove the MAP sensor (1).
  5. Inspect the MAP sensor seal for damage, replace if necessary.
scientia non olet · About LEMON Manuals