LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Manifold Tuning Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake manifold cover. Refer to INTAKE MANIFOLD COVER REPLACEMENT .
    2. Fig 1: Identifying Engine Wiring Harness Electrical Connectors
    GM1675736Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the engine harness electrical connector (1) from the intake manifold tuning valve.
  3. Remove power steering pump. Refer to POWER STEERING PUMP REPLACEMENT .
    4. Fig 2: Removing/Installing Intake Manifold Tuning Valve Bolts
    GM1557831Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold tuning valve bolts.
  5. Remove the intake manifold tuning valve.
scientia non olet · About LEMON Manuals