LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Tank Fill Hose & Clamp
    GM1682044Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel fill pipe assembly.
  2. Install the fuel fill hose to the fuel tank (4).
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Tighten the fuel fill hose clamp (5) at the fuel tank.

    Tighten:   Tighten the bolts to 2.5 Nm (22 lb in).

  4. Connect the fuel fill pipe vapor recirculation pipe (2) quick connect fitting to the fuel tank vapor recirculation hose (3). Refer toPlastic Collar Quick Connect Fitting Service .
  5. Install the fuel fill pipe bracket bolt (1).

    Tighten:   Tighten the bolts to 25 Nm (18 lb ft).

    6. Fig 2: Identifying Fill Pipe Shields & Retainers/Fuel Fill Pocket Bolts
    GM1682277Courtesy of GENERAL MOTORS CORP.
  6. Install the fuel fill pipe shield.
  7. Install the fuel fill pipe shield retainers.
  8. Lower the vehicle.
    9. Fig 3: Identifying Fill Pipe/Fuel Fill Pocket Bolts
    GM1682276Courtesy of GENERAL MOTORS CORP.
  9. Install the fuel fill pipe to fuel fill pocket bolts.

    Tighten:   Tighten the bolts to 2.5 Nm (22 lb in).

  10. Refill the fuel tank.
  11. Install the fuel fill cap.
  12. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals