LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the exhaust manifold. Refer to EXHAUST MANIFOLD REPLACEMENT - RIGHT (3.9L) .
    2. Fig 1: Identifying Crankshaft Position (CKP) Sensor
    GM1712672Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the engine harness electrical connector from the crankshaft position (CKP) sensor.
  3. Remove the CKP sensor stud (2).
  4. Remove the CKP sensor (1).
scientia non olet · About LEMON Manuals