LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the power steering pump. Refer to POWER STEERING PUMP REPLACEMENT .
    2. Fig 1: Disconnecting/Connecting Camshaft Position (CMP) Sensor Electrical Connector
    GM1599076Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the camshaft position (CMP) sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
  5. Inspect the sensor O-ring for wear, cracks or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals