LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Entertainment Systems) >> Repair Instructions >> Antenna Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Navigation Antenna Coaxial Cable
    GM1204244Courtesy of GENERAL MOTORS CORP.
  1. Install the antenna cable (1) to the vehicle. Use electrical tape in order to secure the antenna cable to the top of the wiring harness. Secure the cable to the harness at least every 150 mm (6 in).
    2. Fig 2: View of Antenna Extension Cable
    GM1551265Courtesy of GENERAL MOTORS CORP.
  2. Connect the antenna cable to the antenna extension cable.
  3. Install the carpet. Refer to Carpet Replacement - Front in Interior Trim.
  4. Install the lower center pillar trim panel. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  5. Install the left lower pillar garnish molding. Refer to Garnish Molding Replacement - Lower Pillar in Interior Trim.
    6. Fig 3: View Of Radio Antenna Module & Antenna Cable
    GM1203709Courtesy of GENERAL MOTORS CORP.
  6. Connect the antenna cable (2) to the radio antenna module
  7. Install the headliner. Refer to Headliner Replacement in Interior Trim.
  8. Install the left rear upper quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper in Interior Trim.
  9. Install the left rear quarter lower trim panel. Refer to Trim Panel Replacement - Rear Quarter Lower in Interior Trim.
  10. Install the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) in Seats.
  11. Install the rear seat cushion. Refer to Seat Cushion Replacement - Rear in Seats.
scientia non olet · About LEMON Manuals