LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Entertainment Systems) >> Repair Instructions >> Coaxial Cable Replacement - Digital Radio >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Digital Radio Receiver
    GM1203693Courtesy of GENERAL MOTORS CORP.
  1. Install the new antenna cable to the retainers on the receiver bracket.
  2. Connect the antenna cable to the digital radio receiver.
  3. Route the antenna cable through the rear seat back pass through into the passenger compartment. Wrap the cable and harness with tape at the pass through to avoid abrasion and rattles.
  4. Secure the antenna cable to the wire harness in the rear compartment.
  5. Install the rear compartment trim panel.
    6. Fig 2: View Of Radio Antenna Module & Antenna Cable
    GM1203709Courtesy of GENERAL MOTORS CORP.
  6. Connect the antenna cable (3) to the antenna base cable connector.
  7. Secure the antenna cable to the wire harness.
  8. Install the headliner. Refer to Headliner Replacement in Interior Trim.
  9. Install the rear window shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
scientia non olet · About LEMON Manuals