LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Junction Block Replacement - Accessory Wiring >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install fasteners (1) securing the electrical center (2) to vehicle.

    Tighten:  Tighten the fasteners to 10 N.m (86 lb in).

    Fig 1: Identifying Fasteners & Electrical Center Bracket
    GM1592792Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the fasteners (1) securing the electrical center board (2).

    Tighten:  Tighten the fasteners to 7 N.m (62 lb in).

    Fig 2: Identifying Fasteners & Electrical Center Board
    GM1592791Courtesy of GENERAL MOTORS CORP.
  3. Connect the positive battery cable. Refer to Battery Positive and Negative Cable Replacement (RPO LS4) or Battery Positive and Negative Cable Replacement (RPOs LZE/LZ4/LZ9) .
  4. Install the electrical center cover (1).
    Fig 3: Identifying Electrical Center Cover
    GM1592786Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals