Test Description

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

3: This step tests if the instrument panel cluster (IPC) is able to turn ON the Traction Off indicator.

Traction Off Indicator Inoperative

Step	Action	Yes	No
Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views or Instrument Panel, Gages, and Console Connector End Views in Instrument Panel, Gages, and Console
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn OFF the ignition for 5 seconds. Turn ON the ignition while observing the Traction Off indicator. Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?	Go to Diagnostic Aids	Go to Step 3
3	Install a scan tool. Select the Instrument Panel Cluster (IPC) Special Functions menu on the scan tool. Command the IPC lamps ON. Does the Traction Off indicator turn ON?	Go to Step 5	Go to Step 4
4	Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 6	-
5	Replace the electronic brake control module (EBCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 6	-
6	Turn OFF the ignition for 5 seconds. Turn ON the ignition while observing the Traction Off indicator. Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?	System OK	Go to Step 3