LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 5 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
    2. Fig 1: Identifying I/P Module Connector To Vehicle Harness Connector
    GM816857Courtesy of GENERAL MOTORS CORP.
  2. Connect the I/P module connector (1) to the vehicle harness connector (2).
  3. Install the CPA to the I/P module connector (1).
  4. Install the right outer trim cover to the I/P (3). Refer to Instrument Panel (I/P) Outer Trim Cover Replacement - Right .
  5. Install both Air Bag Fuses, one in the underhood fuse center and one in the interior fuse center.
  6. Replace both fuse center covers.
  7. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals