Enabling Procedure
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition switch.
- Connect both front end sensor connectors (2, 5) to each front end sensor (1, 4).
- Install both CPA's (3, 6) into each front end sensor connector (2, 5).
- Install the radiator upper air baffle and deflector.
- Install both Air Bag Fuses, one in the underhood fuse center and one in the interior fuse center.
- Replace both fuse center covers.
- Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle .