LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Engine Control System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Oil Seal & Camshaft Position (CMP) Sensor
    GM1411952Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring seal with clean engine oil.
  2. Install the O-ring seal (704) onto the CMP sensor, if necessary.
  3. Install the CMP sensor (703).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Remove the CMP sensor bolt (705).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

    5. Fig 2: Connecting The Sensor Electrical Connector
    GM1554556Courtesy of GENERAL MOTORS CORP.
  5. Connect the CMP sensor electrical connector.
scientia non olet · About LEMON Manuals