LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Control System - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Wire Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing The Spark Plug Wire Assembly
    GM1608803Courtesy of GENERAL MOTORS CORP.
  1. Install the spark plug wire assembly.
  2. Install the right side spark plug wire clip at the ignition coil bracket.
  3. If only one plug wire was replaced, install the plug wire and close the retaining clip.
  4. Connect the right side spark plug wires to the ignition coil.
  5. Connect the right side spark plug wires to the right side spark plugs.
    6. Fig 2: Installing The Spark Plug Wire Assembly
    GM1608802Courtesy of GENERAL MOTORS CORP.
  6. Install the spark plug wire assembly.
  7. Install the left side spark plug wire clips at the intake manifold bracket and heater inlet and outlet pipe.
  8. If only one plug wire was replaced, install the plug wire and close the retaining clips.
  9. Connect the left side spark plug wires to the ignition coil.
  10. Connect the left side spark plug wires to the spark plugs.
  11. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals