LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Control System - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting The Manifold Absolute Pressure (MAP) Sensor Electrical Connector
    GM1608869Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (1).
  3. Remove the spark plug wire clip from the intake manifold bracket, if necessary.
    4. Fig 2: Removing The MAP Sensor And Bracket
    GM1608814Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper intake manifold bolts.
  5. Remove the MAP sensor and bracket.
  6. Remove the MAP sensor seal from the upper intake manifold.
scientia non olet · About LEMON Manuals