LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel .
  2. Remove the electrical connector position assurance (CPA) clip.
    3. Fig 1: Disconnecting Accelerator Pedal Position Sensor Electrical Connector
    GM1544734Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the accelerator pedal position sensor electrical connector.
  4. Remove the accelerator mounting bolts (1) from the accelerator bracket.
  5. Remove the accelerator assembly (2) from the vehicle.
scientia non olet · About LEMON Manuals