LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Torque Tube Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Torque Tube & Differential Pinion Shaft
    GM630652Courtesy of GENERAL MOTORS CORP.
  1. Align the splines on the torque tube shaft to the differential pinion shaft.
  2. Install the torque tube (1) to the differential (2).
    3. Fig 2: Torque Tube And Components
    GM630649Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the torque tube-to-bracket through bolt (7).

    Tighten:  Tighten the torque tube-to-bracket through bolt nut (1) to 64 N.m (47 lb ft).

    4. Fig 3: Identifying Torque Tube-To-Differential Bolts
    GM630651Courtesy of GENERAL MOTORS CORP.
  4. Install the torque tube-to-differential carrier bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  5. Install the front propeller shaft. Refer to Propeller Shaft Replacement .
  6. Remove the jack stand from under the front of the rear differential.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals