LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Wiper Arm Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Aligning Wiper Blade
    GM1480133Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper blade onto the wiper arm.
  2. Position the wiper arm onto the wiper arm pivot shaft.
  3. Align the wiper blade tip to the horizontal mark on the windshield within the blackout area (a or b).
    4. Fig 2: Removing/Installing Wiper Arm
    GM1480118Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Hold the wiper arm into position (1) while tightening the nut.
  4. Install the wiper arm nut (4).

    Tighten:  Tighten the nut to 48 N.m (35 lb ft).

  5. Install the wiper arm nut cover (3)
  6. Connect the washer nozzle hose to the washer pump hose (5).
  7. Close the hood.
  8. Inspect the wipers for proper operation.
scientia non olet · About LEMON Manuals