LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Grommets
    GM1480123Courtesy of GENERAL MOTORS CORP.
  1. Install new grommets into the washer container for the wiper washer pumps.
  2. Install the following removed components:
    • Cap
    • Front washer pump
    • Rear washer pump, if equipped
  3. Pull the engine harness forward and lower the container into the engine compartment.
  4. Position the underhood electrical harness over the top of the washer container spout.
  5. Position the washer container (2) to the right front inner fender.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the bolts.

    Tighten:  Tighten the washer container bolts in sequence, as shown, to 6 N.m (53 lb in).

  7. Connect the washer jumper hoses.
  8. Connect the electrical connectors.
  9. Install the right front diagonal brace. Refer to Brace Replacement - Sheet Metal Diagonal (Chevrolet) or Brace Replacement - Sheet Metal Diagonal (Pontiac) or Brace Replacement - Sheet Metal Diagonal (Buick) in Body Front End.
  10. Reposition the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
  11. Refill the washer container with new washer solvent.
  12. Verify the operation of the wipers/washer systems.
scientia non olet · About LEMON Manuals