LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> TrailBlazer 5.3 M, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 366 (Adjustable Pedal System) >> Repair Instructions >> Accelerator Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Accelerator Pedal Assembly Removed
    GM1302012Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal on the mounting studs.
    2. NOTE: Refer to Fastener Notice .
  2. Install the mounting nuts.

    Tighten:  Tighten the mounting nuts to 11 N.m (97 lb in).

    3. Fig 2: Locating Accelerator Pedal Mounting Bolt
    GM1334507Courtesy of GENERAL MOTORS CORP.
  3. Install the mounting bolt behind the accelerator pedal.

    Tighten:  Tighten the mounting nuts to 11 N.m (97 lb in).

    4. Fig 3: Accelerator Pedal
    GM1301966Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The following procedure must be performed before if the accelerator pedal or brake pedal drive motor and cable assembly are being replaced. Failure to do so could cause an IMPROPER STEP OVER HEIGHT.
  4. Adjust the accelerator pedal in the following sequence:
    1. Turning the motor transmission clockwise reduces the gap, and counterclockwise increases the gap.
    2. Position a 4.5 mm (0.187 in-3/16 in) drill bit or equivalent in number and/or letter drill bits, 6.35 mm (0.25 in-1/4 in) from the bottom of the metal accelerator pivot arm.
    3. Rotating the drive cable by hand, adjust the accelerator motor transmission until the 4.5 mm (0.187 in-3/16 in) drill bit or equivalent in number and/or letter drill bits, fits snugly between the plastic accelerator arm and the metal pivot arm.
    5. Fig 4: Locating Drive Cable
    GM1218555Courtesy of GENERAL MOTORS CORP.
  5. Install the drive cable.
    6. Fig 5: Identifying Drive Cable Lock Collar
    GM1218552Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the secondary locking tabs are fully seated before installing the lock collar for the drive cable.
  6. Install the drive cable lock collar.
    7. Fig 6: Rotating Drive Cable Lock Collar To Lock Position
    GM1301880Courtesy of GENERAL MOTORS CORP.
  7. Rotate the drive cable lock collar to the lock position.
    8. Fig 7: View Of Accelerator Pedal Electrical Connector
    GM1218569Courtesy of GENERAL MOTORS CORP.
  8. Install the electrical connection for the accelerator.
    9. Fig 8: Locating Knee Bolster Trim Panel
    GM712827Courtesy of GENERAL MOTORS CORP.
  9. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  10. Verify the operation of the adjustable pedals.
scientia non olet · About LEMON Manuals