LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> TrailBlazer 5.3 M, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Secondary And Configurable Customer Controls) >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu Ascender, 2007 GMC Envoy, 2007 Chevrolet TrailBlazer, and 2007 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
    2. Fig 1: View Of Shroud & Screws
    GM755486Courtesy of GENERAL MOTORS CORP.
  2. Remove the shroud retaining screws from the back of the steering wheel.
  3. Remove the shroud from the steering wheel.
    4. Fig 2: View Of Wire Harness Cavity
    GM755485Courtesy of GENERAL MOTORS CORP.
  4. Position a blunt ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control switch from the steering wheel.
    5. Fig 3: View Of Steering Wheel Control Switch Electrical Connector
    GM652807Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the steering wheel control switch electrical connector.
    6. IMPORTANT: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.
  6. Remove the steering wheel control switch from the steering wheel.
scientia non olet · About LEMON Manuals