LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> TrailBlazer 4.2 S, 4WD >> Repair and Diagnosis >> Electrical >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Console Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Console Assembly
    GM741613Courtesy of GENERAL MOTORS CORP.
  1. If replacing the floor console base, install the following:
    1. Install the HVAC upper duct.
    2. Install the cupholder.
    3. Install the HVAC module and duct assembly.
    4. Install the armrest.
    5. Install the HVAC control module (if equipped).
  2. Position the center console to the vehicle.
  3. Adjust the parking brake to the full-up, or fully engaged position.
  4. Connect the electrical connectors, as necessary.
  5. Lower the rear of the console and slide the console forward into position.
  6. Ensure that the 2 retaining ears on the front extensions of the console are fully engaged to the lower I/P, Buick only.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the center console retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  8. Install the console storage compartment. Refer to Console Storage Bin Replacement .
  9. Install the center console shift lever bezel, Buick only. Refer to Console Shift Lever Bezel Replacement (Buick) .
  10. Install the floor shift control knob. Refer to Floor Shift Control Knob Replacement .
  11. Install the rubber ash tray inserts and rubber mat to the console.
  12. Remove the blocks from the vehicle.
scientia non olet · About LEMON Manuals