LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Lighting Systems) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Pedal Position Sensor Screw
    GM1204637Courtesy of GENERAL MOTORS CORP.
  1. Apply adhesive GM P/N 12345493 (Canadian P/N 10953488) to the screw.
  2. Position the sensor fork to the pin.
  3. Rotate the sensor in order to align the sensor locator to the hole in the extension bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the brake pedal position sensor screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    5. Fig 2: Electrical Connector & CPA
    GM1204640Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2).

    Engage the CPA. The CPA will not engage if the connector is not attached properly.

  6. Calibrate the sensor. Refer to Brake Pedal Position Sensor Calibration .
  7. Install the I/P insulator. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals