LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Engine Controls - 7.0L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Control Module (ECM) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing The ECM To The ECM Bracket
    GM1676010Courtesy of GENERAL MOTORS CORP.
  1. Install the ECM to the ECM bracket.
    Fig 2: Connecting The Electrical Connectors To The ECM
    GM1676014Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Connect the electrical connectors to the ECM.

    Tighten:  Tighten the ECM electrical connectors to 8 N.m (70 lb in).

  3. Install the wheelhouse filler panel. Refer to Fender, Insulator, Liner, Brake Caliper Cooling Duct Replacement - Front .
  4. If a new ECM is being installed, program the ECM. Refer to Control Module References .
scientia non olet · About LEMON Manuals