LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 3 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition in the OFF position.
    2. Fig 1: CPA, Vehicle Harness Yellow Connector, Steering Wheel Module Coil Yellow Connector
    GM1246630Courtesy of GENERAL MOTORS CORP.
  2. Connect the steering wheel module coil yellow connector (3) to the vehicle harness yellow connector (2).
  3. Install the CPA (1) to the vehicle harness yellow connector (2).
  4. Install the left sound insulator to the I/P. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower in Instrument Panel, Gages and Console.
    5. Fig 2: Kick-Up Panel, I/P Fuse Block & Cover
    GM1246577Courtesy of GENERAL MOTORS CORP.
  5. Install the SDM fuse into the I/P fuse block.
  6. Install the I/P fuse block cover (1).
  7. Install the kick-up panel (2) to cover the I/P fuse block (1).
  8. Use caution while reaching in and place the ignition to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  9. Perform the Vehicle System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals