LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Seat Cushion Frame
GM71217Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the adjuster to the seat. Tighten the fasteners to the seat.

    Tighten:  Tighten the adjuster fasteners to 24 N.m (18 lb ft).

    2. Fig 2: Seat Adjuster Adjustment Bar
    GM281997Courtesy of GENERAL MOTORS CORP.
  2. For non-power seats, align the adjusters with their locking pawls engaged in the same slots side to side.
  3. Install the seat adjuster adjustment bar.
    4. Fig 3: View Of Pump & Lumbar Control Module
    GM339492Courtesy of GENERAL MOTORS CORP.
  4. Install the lumbar pump, if equipped.

    Tie strap the pump to the torque tube.

  5. Connect the seat belt harness to the left seat.
    6. Fig 4: Wire Assembly To Seat Cushion Frame
    GM281999Courtesy of GENERAL MOTORS CORP.
  6. Install the memory seat control module to the seat spring wire, if equipped.
    7. Fig 5: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  7. Install the seat belt pretensioner and buckle. Refer to Seat Belt Buckle Pretensioner Replacement .
  8. Install the seat cushion foam and cover. Refer to Seat, Cushion, Cover, Pad Replacement - Front Seat .
  9. Install the seat. Refer to Seat Replacement .
scientia non olet · About LEMON Manuals