LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Controls - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Control Module (ECM) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: PCM & Mounting Bracket
GM519845Courtesy of GENERAL MOTORS CORP.
  1. Install the ECM to the ECM rear bracket.
  2. Position the ECM front bracket.
    NOTE: Refer to Fastener Notice .
  3. Install the ECM front retaining fasteners.

    Tighten:  Tighten the ECM retaining fasteners to 2 N.m (17 lb in).

    4. Fig 2: PCM Electrical Harness Connectors
    GM519848Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connectors to the ECM.

    Tighten:  Tighten the ECM electrical connectors to 8 N.m (70 lb in).

  5. Install the wheelhouse filler panel. Refer to Fender, Insulator, Liner, Brake Caliper Cooling Duct Replacement - Front .
  6. If a new ECM is being installed, program the ECM. Refer to Control Module References .
scientia non olet · About LEMON Manuals