Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Control Arm & Stabilizer Shaft Link

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft to the vehicle.

NOTE: Refer to Fastener Notice .

Install the stabilizer shaft insulator clamps to the stabilizer shaft and the crossmember.
Tighten:
- Tighten the stabilizer shaft insulator clamp bolts to 65 N.m (49 lb ft).
- Tighten the stabilizer shaft insulator clamp nuts to 95 N.m (70 lb ft).
Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft links to the stabilizer shaft.
Tighten: Tighten the stabilizer shaft link nuts to 76 N.m (56 lb ft).
Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.