LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Control Arm & Stabilizer Shaft Link
    GM922511Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft links and link nuts to the stabilizer shaft and to the lower crossmember.

    Tighten:  Tighten the stabilizer shaft link nuts to 76 N.m (56 lb ft).

  2. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals