LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Rear Suspension System) >> Repair Instructions >> Knuckle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Speed Sensor Electrical Connectors
    GM919156Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Disconnect the wheel speed sensor harness connector.
  4. Disconnect the ESC position sensor link. Refer to Rear Position Sensor Replacement - Electronic Suspension .
  5. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .
  6. Separate the outer tie rod end from the suspension knuckle. Refer to Tie Rod Replacement (Inner) .
  7. Remove the spindle nut retainer, the spindle nut and the washer. Refer to Wheel Drive Shaft Replacement .
    8. Fig 2: Upper Control Arm, Lower Control Arm & Suspension Knuckle
    GM922513Courtesy of GENERAL MOTORS CORP.
  8. Separate the suspension knuckle from the upper control arm. Refer to Rear Axle Upper Control Arm Replacement (Except RPO FE4)  or Rear Axle Upper Control Arm Replacement (RPO FE4 (Z06)) .
  9. Separate the suspension knuckle from the lower control arm ball joint stud. Refer to Rear Axle Lower Control Arm Replacement .
  10. Remove the suspension knuckle.
scientia non olet · About LEMON Manuals