LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Rear Suspension System) >> Repair Instructions >> Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Control Arm, Lower Control Arm & Suspension Knuckle
    GM922513Courtesy of GENERAL MOTORS CORP.
  1. Install the suspension knuckle to the lower control arm ball joint stud. Refer to Rear Axle Lower Control Arm Replacement .
  2. Install the suspension knuckle ball joint stud to the upper control arm. Refer to Rear Axle Upper Control Arm Replacement (Except RPO FE4)  or Rear Axle Upper Control Arm Replacement (RPO FE4 (Z06)) .
  3. Install the spindle nut, washer and retainer. Refer to Wheel Drive Shaft Replacement .
  4. Install the outer tie rod end to the suspension knuckle. Refer to Tie Rod Replacement (Inner) .
  5. Install the brake rotor and caliper. Refer to Rear Brake Caliper Bracket Replacement and Front Brake Rotor Replacement .
    6. Fig 2: View Of Wheel Speed Sensor Electrical Connectors
    GM919156Courtesy of GENERAL MOTORS CORP.
  6. Connect the wheel speed sensor harness connector.
  7. Connect the ESC position sensor link. Refer to Rear Position Sensor Replacement - Electronic Suspension .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
  10. Perform a rear wheel alignment. Refer to Measuring Wheel Alignment .
scientia non olet · About LEMON Manuals