Installation Procedure

Fig 1: Brake Pipe To Brake Master Cylinder Removed

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the brake pipe to the brake master cylinder.
Tighten: Tighten the brake pipe fitting 25 N.m (18 lb ft).

Fig 2: Rear Brake Pipe Removed

Courtesy of GENERAL MOTORS CORP.

Install the rear brake pipe.
Tighten: Tighten the brake pipe fitting to 25 N.m (18 lb ft).

Fig 3: Right Front Brake Pipe Removed

Courtesy of GENERAL MOTORS CORP.

Install the right front brake pipe.
Tighten: Tighten the brake pipe fitting to 25 N.m (18 lb ft).

Fig 4: Electronic Brake Control Module (EBCM) View

Courtesy of GENERAL MOTORS CORP.

Install the left front brake pipe.
Tighten: Tighten the brake pipe fitting to 25 N.m (18 lb ft).
Install the EBCM to the vehicle. Refer to Brake Pressure Modulator Valve (BPMV) Replacement .
Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Bleed the brake system. Refer to ABS Automated Bleed Procedure .