LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Cable Replacement (7.0L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the positive battery cable.
    2. Fig 1: View Of Positive Cable & Grommet
    GM1672702Courtesy of GENERAL MOTORS CORP.
  2. Push the positive cable grommet into place in the dash panel.
    3. Fig 2: View Of Positive Battery Cable Retainers
    GM1672703Courtesy of GENERAL MOTORS CORP.
  3. Position the positive battery cable to retainers.
  4. Position the carpet back.
  5. Install the right door sill plate. Refer to Door Sill Plate Replacement .
  6. Install the passenger rear compartment front side trim panel. Refer to Rear Compartment Side Trim Panel Replacement .
  7. Install the rear compartment carpet. Refer to Rear Compartment Floor Panel Carpet Replacement (Convertible) or Rear Compartment Floor Panel Carpet Replacement (Coupe) .
    8. Fig 3: View Of Positive Battery Cable Lead & Nut
    GM1704615Courtesy of GENERAL MOTORS CORP.
  8. Install the positive cable lead (2) to the fuse/relay center stud.
    9. NOTE: Refer to Fastener Notice .
  9. Install the positive battery cable nut (1) to the fuse/relay center stud.

    Tighten:  Tighten the positive battery cable nut to 10 N.m (89 lb in).

  10. Close the stud cover on the fuse/relay center.
  11. Connect the positive battery cable to the battery.
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L)  or Battery Negative Cable Disconnection and Connection (7.0L) .
scientia non olet · About LEMON Manuals