LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC 024 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
  • The PPS module
  • The PPS wiring harness connector
  1. Ignition OFF, disconnect the PPS module connector. Refer to PPS replacement in Repair Instructions for location of connector.
  2. Test the PPS ground circuit for an open or high resistance. Verify that an open or high resistance does not exist.
    • If any of the above conditions are found make the appropriate repair.
  3. Test the PPS ignition 1 voltage circuit for a short to ground, an open, or high resistance. Verify that a short to ground, an open, or high resistance does not exist.
    • If any of the above conditions are found make the appropriate repair.
  4. Reconnect all PPS components. Use the scan tool to clear all PPS DTCs. Refer to Passenger Presence System Flash Code Procedures . Rezero the PPS, refer to Passenger Presence System Rezeroing Procedure . Verify DTC 024 does not exist.
    • If DTC 024 reset replaced the PPS.
scientia non olet · About LEMON Manuals