LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Optra LS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 1.6L (L91) >> Diagnostic Information and Procedures >> DTC P0112 or P0113 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector of the IAT sensor.
  2. Ignition ON, verify that the IAT sensor parameter is at -40°C (-40°F).
    • If greater than -40°C (-40°F), test the signal circuit of the IAT sensor for a short to ground. If the circuit/connections test normal, replace the ECM.
  3. Test for less than 0.5 volt between the low reference circuit of the IAT sensor and ground.
    • If greater than 0.5 volt, test the low reference circuit of the IAT sensor for a short to voltage. If the circuit/connections test normal, replace the ECM.
  4. Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit of the IAT sensor and ground.
    • If greater than 5 ohms, test the low reference circuit of the IAT sensor for an open/high resistance. If the circuit/connections test normal, replace the ECM.
  5. Install a 3-amp fused jumper wire between the signal circuit and the low reference circuit of the IAT sensor and verify the IAT sensor parameter is greater than 128°C (262°F).
    • If less than 128°C (262°F), test the signal circuit of the IAT sensor for a short to voltage or an open/high resistance. If the circuit/connections test normal, replace the ECM.
  6. If all circuits/connections test normal, test or replace the IAT sensor.
scientia non olet · About LEMON Manuals