LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Optra LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Front Suspension) >> Repair Instructions >> Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Optra5 and 2005 Chevrolet Optra. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Control Arm-To-Crossmember Bolts
    GM1290650Courtesy of GENERAL MOTORS CORP.
  1. Install the control arm.
  2. Install the control arm-to-crossmember bolts. Do not tighten the bolts.
    3. Fig 2: View Of Ball Joint Pinch Bolt And Nut
    GM1290631Courtesy of GENERAL MOTORS CORP.
  3. Connect the ball joint to the steering knuckle.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the ball joint pinch bolt and the nut.

    Tighten:  Tighten the ball joint pinch bolt nut to 60 N.m (44 lb ft)  .

    5. Fig 3: View Of Control Arm
    GM1290651Courtesy of GENERAL MOTORS CORP.
  5. Install the control arm-to-crossmember bolts.

    Tighten: 

    • Tighten the front control arm-to-crossmember bolt to 125 N.m (92 lb ft)  .
    • Tighten the rear control arm-to-crossmember bolt to 110 N.m (81 lb ft)  .

  6. Install the wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals