LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Optra LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Controls - 1.8L (L79) - Introduction And Mechanical Repairs) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Optra5 and 2005 Chevrolet Optra. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of TP Sensor And Retaining Bolts
    GM1256154Courtesy of GENERAL MOTORS CORP.
  1. With the throttle valve closed, position the TP sensor on the throttle shaft. Align the TP sensor with the bolt holes.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the TP sensor retaining bolts.

    Tighten:  Tighten the TP sensor retaining bolts to 2 N.m (18 lb in)  .

  3. Connect the TP sensor connector.
  4. Install the air intake tube and resonator.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals