LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Optra LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel And Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Optra5 and 2005 Chevrolet Optra. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Ignition Switch Wiring And Retaining Screw
    GM1308230Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch with the ignition switch retaining screw.

    Tighten:  Tighten the ignition switch retaining screw to 2.5 N.m (22 lb in)  .

  2. Connect the wiring to the ignition switch.
    3. Fig 2: Identifying Steering Column Cover Panel Screws
    GM1308107Courtesy of GENERAL MOTORS CORP.
  3. Install the lock cylinder.
  4. Connect the electrical connector for the immobilizer detection unit.
  5. Install the upper and the lower steering column cover panel with the screws.

    Tighten:  Tighten the upper and the lower steering column cover panel screws to 2.5 N.m (22 lb in)  .

  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals