LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Optra LS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 1.6L (L91) >> Diagnostic Information and Procedures >> DTC P0341 or P0342 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector of the CMP sensor.
  2. Ignition ON, test for battery voltage between the ignition 1 voltage circuit of the CMP sensor and ground.
    • If less than B+, repair the ignition 1 voltage circuit of the CMP sensor for a short to ground or an open/high resistance.
  3. Connect a test lamp between the ground circuit and the ignition 1 voltage circuit of the CMP sensor.
    • If the test lamp does not illuminate, test for an open/high resistance on the ground circuit. If circuit/connections test normal, replace the ECM.
  4. Ignition OFF, connect a DMM between the signal circuit and the low reference circuit of the CMP sensor.
  5. Ignition ON, verify that 4.8-5.2 volts is available on the signal circuit and the low reference circuit of the CMP sensor.
    • If less than 4.8 volts, test the signal circuit for a short to ground or an open/high resistance. If the circuits/connections test normal, replace the ECM.
    • If more than 5.2 volts, test the signal circuit for a short to voltage. If the circuits/connections test normal, replace the ECM.
  6. If all circuits/connections test normal, replace the CMP sensor.
scientia non olet · About LEMON Manuals